Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im having trouble capturing RTP VoiP Media with the embedded packet capture feature on an ME3600X. Anyone have similar experience with this? I did an inline capture by creating a SPAN port and the traffic was there. When I utilize the embedded pac...
Hi All,I am practicing on a home lab to attain my CCNP Switch. My home lab is comprised of a couple of 3550 switches. I tried to configure DHCP snooping without any luck. I am running IOS ver. 12.2(25) SEA. I program the feature as it states on t...
I have two sites connected via a Point to Point T1 link. In each side of the point to point link I have two different subnets (i.e. 192.168.2.0 and 192.168.3.0). I have a a full copy of each other on each side of the link (just in case it goes down...
Hopefully I am wording this decent enough to understand. I am working in a team where we are deploying VMware for a business that has two locations that are connected via a point-to-point wan connection. At each end of that connection they have Cis...
Hi Colby. If my NAC deployment was 70% mab with only 30% dot1x, would you still advocate for a Dot1x then mab order first (with the timeouts like you mention?). My concern with that order is with dealing with a bunch of dumb IoT devices that may be ...
Here is the basic config that I was originally looking for. This is how you essentially create Sub-Interfaces on a single physical interface and how you accommodate the dot1q tag.
bridge-domain 100bridge-domain 200bridge-domain 900!
interface Giga...
Hi Mithun,
Thank You for your example above, as I am currently trying to set this up as well. One question though....does the ehwic-VA-dsl-A module come with software by default, or do you need the "firmware filename flash:vdsl.bin-A2pv6C035j1" com...
Since you don't mention Spanning-tree protocol in this syntax (vs. bridge X protocol ieee), is it a given? Or.....do you specify spanning-tree protocol somewhere else? -----------------------My4321-cir1(config)#bridge 1 protocol ? dec DEC ...
