Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thanks in advance for any advice or input. I recently acquired a Cisco 3750G-48PS-S switch for a CCNA lab I am putting together. In console, when the switch boots I get the following failure/error. Wondering if anyone has seen this before and if i...
We received some Cisco CP-7945G phones from our head office to replace the CP-7940G's we had in place. I'm having an issue with these phones, when powered on and plugged into the network, they are stuck on initializing for a few minutes, then they t...
Actually, I think they are trying to provision or connect to a Callmanager or TFTP that they were previously configured for. Anyone know how to glean the IP address they are trying to connect to and force feed them new config files? I'm a bit of a ...
Smailmilak83 - When referring to Optical Fiber cabling, the term LC stands for Lucent Connector. LC is a small form-factor fiber optic connector. LC Connectors use a 1.25mm ferrule, roughly half the size of an ST Connector. LC offers good perfo...
Erik - you should be able to use any of the following transceivers with your CE500, you may need to check your IOS in conjunction with the transceiver you are trying to use to make sure you meet the IOS requirements:GLC-LH-SMGLC-SX-MMGLC-GE-100FXGLC-...
