Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured NAT on the cisco router and wanted to do a address translation for the destination address. My local LAN is 192.168.1.0/24. My server is in a different network 192.168.2.2. from My 192.168.1.0/24 network, i would like to give dummy ...
I have a scenario where i my source network needs to communicate over two different clients having same private IP address range 192.168.1.0/24 over different paths. Please let me know what is the best way to achieve in cisco router/firewallThanks in...
I configured Client to Site with Cisco ASA 7 with Cisco VPN Clinet 5.0. I was able to successfully connect to the VPN Server but i could not connect to any of the network inside. I enabled NAT Traversal but still i could not ping. I enabled IP and IC...
I would like to know the configuration of Cisco ASA Active/Active. Since active/active works in multiple context mode. i was trying to configure one firewall as primary but i was not able to provide ip address for the interfaces. The command is not g...
I had set up Cisco ACS for TACACS authentication for Cisco Aironet and Cisco ASA. Unfortunately the server crashed and i did not have backup. But i had the secret key and other server information. I re-installed the Cisco ACS and could successfully a...
In the failed attempts i am getting "un-known" When iam trying to initiate a telent connection, in the console of the Pix i could see "aaa server host machine not responding". I believe there is some setting in the ACS which i am missing out.
No i do not have. I was setting up the environment when the server crashed and hence no backup. I am sure that once i get the TACACS configured, things should be fine since using the same TACACS i was able to connect back to cisco Aironet
Hi,Thanks for your mail. I am not sure whether this is a natural behaviour, but in the access switches when i give sh spantree vlan no, ideally i should get one port in blocking and one port in forwarding and for some vlan i could see 30 ports in for...
