Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attempted to upgrade the firmware on my 2500W camera from 1.1X to 2.1.7 via web interface. It appeared that the upgrade went well but upon reboot, the camera bricked. I can ping the camera, but no web interface. I attempted to reinstall using the ...
I am running version 7.0.164.0 on my WCS and have a 2700 and a 2710 Location Appliance both running version 6.0.102.0. I used to be able track clients on the WCS maps but now I am not able to. No clients show up on the maps anymore, just the APs an...
Upgraded to 6.0.196 code and now I am getting a large number of the following errors that were not previously reported in version 5 code. Is there any way to turn these off?MFP Anomaly Detected - 7 Out of sequence event(s) found as violated by the r...
I remembering setting a username and password for FTP transfers when I originally installed my WCS way back when. Now that the images are getting increasingly larger and the controllers support FTP transfers, I would like to begin using FTP to upgra...
Did all that and nothing. I was able to upgrade another cam so I have everything set up correctly. This one cam was upgraded incorrectly and now bricked. I was was looking for some recovery procedure.
