Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. We have a working system using PI2.1 and MSE 8.0. On PI under site map properties the units of measure is set to metres and all maps have the correct dimensions and APs and clients displaying in the correct locations. When I view a map using the ...
Hi All,Wondering what are below highlighted value as they are used for route preferences. pe401c6506#sh ip bgp vpnv4 vrf DATA 10.18.0.0/16BGP routing table entry for 10.254.0.253:120:10.18.0.0/16, version 157413Paths: (2 available, best #2, table DAT...
Hi All,Just want to see if anyone could help me out on the issue that outbound call through MGCP GW to PSTN failed while inbound calls from PSTN are fine.Please find enclosed Topology Diagram along with the config files and debug files from the Cisco...
Hi Folks,I am just wondering if a call can be routed from FXO to FXS. To be more specific, here I have my testing lab setup as below.IP Soft Phone --- 1760 (PVDM 256) FXO ------- FXS 1760 (PVDM 256) FXS --- Analog Phone.Thanks
Hi,According to the Cisco Doco, below setup (part 4) should work if all requirements are met.http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00803736c1.shtmland http://www.networkworld.com/community/node/33087However, I find i...
Hi Nitesh,Thanks for your input. The called party ISDN plan and type appears as what the Telco expects whereas the calling party number and type seems problematic. However, as you advised, I have managed to prefix "410555" on the the calling number w...
