Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is it at all possible with SNMP or other tools to identify the unique number of connections on PIX or ASA. I’m not referring to the number of session or the results of “show conn count” but rather something similar to what “show local host” comman...
Hi,I have WLC 4402 with 9 1131AG APs. Are there any advantages to turning off the a/n radio, and just have the G radio enabled? Most if not all of the clients are connecting using G.Also, are there any settings in the WLC that can be tweeked to opt...
Hi Everyone,We currently have a dual Core setup using a pair of Cisco 4510's. The company is growing and we will adding another 200 users or so for a total of 600. I believe the existing setup will be ok, but I do have enough to upgrade one of them...
I need to add a few static route to an MPLS router running BGP, and I would like these static routes be advertised to the rest of the MPLS NetworkThe current BGP configs are as follows: router bgp 64444 no synchronization bgp router-id 10.0.3.1 bgp l...
Hi, I am aware that I can only have a total of 12 AP's on the WLC2112, but I read somewhere that the controller has a hard limit of 254 client connections. Is this true?Thanks
Thanks for your reply Mahesh. Can you explain what Address-family is?Also, and in my case, I assume I need to add this to both routers? There are two routers with iBGP between themThanks
So i can just add static routes, and issue the redistribute static without the need to advertise the Neworks?Also, this router has iBGP Peer, so I am assuming I need to do the same on the Peer router as well?Thanks
Thank for the reply Dan.If I understand what you suggested, that would advertise the Networks out into BGP, but I still to point these networks to a firewall interface since they are behind it. I would still need the static route, right?Would it be ...
