Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem with one customer, here is the issue. Setup: I have customer#1 with 2 LAN extensions (separate PVC’s) coming from a carrier xylan switch terminating on a 4006 switch on the same VLAN. The customer has 2 routers at their end and they ...
I have a problem with one customer, here is the issue.Setup:I have customer#1 with 2 LAN extensions (separate PVC’s) coming from a carrier xylan switch terminating on a 4006 switch on the same VLAN. The customer has 2 routers at their end and they a...
I have an AP 1200 connected to a Catalyst 2950 IOS 12.1(22)EA1b The AP is using Vlan1 Between the AP 1200 and the 2950, 802.1q trunking running with Vlan 1 and Vlan 20. A Cisco 1600 series router is connected to Vlan 57 and is the default gateway rou...
I know this is an old conversation but the most likely cause of your issue is cdp. Enable cdp on your interface or disable cdp on your next connected device.
The weaknesses of WEP is not only with Cisco AP, any device that uses WEP could be compromise Been from a security background I could only recommend that you use WPA/2 instead of WEP. As per your question it could take you more time to crack the WE...
The wireless roaming is always controlled by the STA and not the AP. Check to see if there are any new driver versions for the STA cards. For example many people complained about the 2915ABG card that recently not roaming properly, or waiting until ...
