About ericgriffin1

ericgriffin1 · 11-29-2010

Hi,I'm trying to configure an SSL vpn on a 1941 router. The vpn connects and I can see the router itself, but not any other networks behind the router. I created the ssl vpn configuration with CCP. IPsec vpn works perfectly and the SSL vpn is conf...

ericgriffin1 · 12-01-2010

Here's my config:version 15.1no service padservice tcp-keepalives-inservice tcp-keepalives-outservice timestamps debug datetime msec localtime show-timezoneservice timestamps log datetime msec localtime show-timezoneservice password-encryptionservice...

ericgriffin1 · 11-29-2010

I can't ping any host on the other side of the tunnel but I can ping any interface on the router. I believe routing is configured ok.Regards,Eric

ericgriffin1 · 11-28-2010

I'm about to attempt getting one to work with CUCM. Did anyone have any luck?

ericgriffin1 · 11-25-2010

Hi Mark,800 series routers are probably most commonly used for connecting small branch offices to a headquarters via vpn or provided as cpe for similar tasks, so gigabit really isn't necessary for their intended purpose. Of course they're edge devic...

ericgriffin1 · 11-25-2010

Hi Mark,When you're switching through the 887 with non-jumbo frame setup are you changing the mtu on your end devices back to 1500 (or disabling jumbo frame support)? If they're still sending jumbo frames the 887 could either be dropping them or fra...

Member Since	‎11-17-2010 09:46 AM
Date Last Visited	‎04-03-2018 09:56 PM
Posts	8
Total Helpful Votes Received	10

User Statistics

User Activity

SSL VPN connects but can't access inside network

Re: SSL VPN connects but can't access inside network

Re: SSL VPN connects but can't access inside network

Re: Configuring the Cisco SPA8800 IP Telephony Gateway in an Asterisk Environment

Re: 887W jumbo frame?

Re: 887W jumbo frame?