Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
First project out of school is to install new WIFI across the plant. The WAPs need to broadcast 2 SSIDs, one for Plant (static IPs) and one for Comcast (DHCP, handled by firewall). Plant SSID currently works and has full connectivity to plant network...
Network that I am trying to access is 199.8.0.0/16 and is on VLAN 1 AP01 joins WLC-1 and begins broadcasting SSID "CISCO2_test". Created a vlan 1 interface:Interface Name Port Vlan Id IP Address Type Ap Mgr Guest-------------------------------...
First time setting up a network with WLC. WLC is configured and can both web browse and SSH into it. It currently has 1 SSID configured. I hardwire one of the APs into port 3 (PoE port) and it doesn't receive the SSID configuration.WLC Firmware is 8...
but if it is problematic then the solution could be to connect on the plant switch to the firewall an access port in vlan 1, an access port in vlan 10, and an access port in vlan 99 and on the Comcast switch connect an access port in vlan 10 and an a...
WAP communicate on both networksAt the moment, the WAPs are plugged into VLAN 1/Plant network (but are trunked) and broadcasting the SSID fine. We want to be able to broadcast a 2nd SSID, while plugged into these trunk ports to broadcast VLAN 10/Comc...
Going to preface your questions with my goal for this project, then come back and answer the questions. I have a new wireless network that I would like to be able to broadcast 2 SSIDs, each SSID is tied to a different VLAN/Network. Network 1: Plant N...
- is it your intention that the new vlan 15 would use the existing DHCP scope from the firewall or would the new vlan have a new DHCP scope on the firewall?I would like for it to be the same DHCP scope - you tell us that you configured the switches i...
Its a checkpoint firewall. I quickly looked through the GUI and couldn't find a way to check to make sure the interface was set to trunk. When I get to work tomorrow, I'll try to GUI in to it.
