Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have two pixes connected to each other in the intranet(LAN) via the inside interfaces on both.On both pixes, the outside interfaces connect to a different dmz.I would like to create a ipsec vpn from the inside interface of one pix to the ins...
I am running a c2600-i-mz.122-5a.bin on this router and it is doing NAT as follows for both source and destination.interface FastEthernet0/0 ip address 10.192.57.228 255.255.255.224 ip access-group 101 in ip nat inside speed auto full-duplex!interfac...
We have a situation where the RSP4 is booting up with a boot file as follows:Router uptime is 22 minutesSystem restarted by reloadSystem image file is "bootflash:rsp-boot-mz_113-7_WA4_10.bin", booted via bootflashcisco RSP4 (R5000) processor with 131...
We are trying to install a Unity (4.0.3) in a Domino 5.0.12 environment. The Domino servers are partitioned servers. Will the install succeed or is the issue that TAC will not support this setup?The unity servers will be on a standalone server, and ...
Hi Tanveer,Thanks for the reply.I also would like to know if the vpn endpoints can be the outside interface. In this scenario, we are using the intranet(that is the tunnel is actually the LAN). Does the pix allow traffic to cross the its interfaces...
Ok, so I formatted the flash card and uploaded the ios on a 7200 and shipped the card to the remote site which has a 7500.However, the 7500 is not seeing the device. Does the 7500 not recognize a flash card formatted on the 7200? I don't have a 750...
There are no files in the file system except the boot file for 11.3 with which the RSP is currently booted up.I don't mind doing xmodem,and I have console access via a PC but I believe it is not possible to do xmodem on the 7500. If it is, can you l...
