Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I’m working with a L3 Core Switch with 4 VLAN´s and 4 sub networks(10 network). I’m using only 10.0.0.0/8 network in all LAN and 172.16.X.X in all WAN. I have a WAN VLAN (VLAN1, Core–router) with 10.10.10.1/29 sub network. I need to put into rout...
Hi, Actually, I have for voice only the Cisco router connected to Avaya PBX with one E1 port for incoming/outgoing calls with g711ulaw code, they are working well, but I’m having problems with the DSP/Ch 0/1:1 when it’s blocked. I see that when this ...
Hi, I have configured step by step PBR on my core switch. The core switch is using 2 L3 VLAN and it has connected 2 routers. Every VLAN has to use one router like default gateway, but If one router fails, all the traffic will be sending to the act...
You´re right.I changed these route-map numbers some days ago, they don´t have the same number now, BUT ! I removed them and I added again some minutes ago and the IP policy is working.Thanks a lot, it´s working now.Best regards, Luis.
I typed next:ROUTER#show ip policyInterface Route mapROUTER#It showed me nothing, later I reviewed the current config and the Interface VLAN1 is showing only the IP address.Thanks, best regards, Luis.
Here the config:ROUTER#show confUsing 8169 out of 524288 bytes!version 12.2no service padservice timestamps debug uptimeservice timestamps log datetimeno service password-encryptionservice sequence-numbers!hostname ROUTER!enable password !no aaa new-...
Hi, based on Cisco document I have enabled sdm prefer dual-ipv4-and-ipv6 routing with PBR. ´´ The software supports IPv4 PBR only when the dual-ipv4-and-ipv6 routing template is configured´´ The show sdm prefer command is showing next: ROUTER#sh sdm...
