Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I've been looking all over Cisco to see if the VG400 support ip routing protocols like BGP, OSPF, EIGRP.
The documentation only mentions the following:Cisco VG400 Voice Gateway Software Configuration Guide - Configuring with the Command-Line I...
Is it possible to have Ikev1 Site to Site VPN's with Cisco ASA 8.4(3) using external policies from an ACS 5.2?I currently have many site to site VPN's with internal group policies and different set of firewalls with the same rules, so changing one st...
Is there a way to copy everything I have from slot0 to slot1 in a CSS 11500 ?When I say everything I am mainly looking at services, content rules, header fields, source groups, ssl certificates?A Cisco rep told me to issue a copy 0 command and I have...
Is it possible for a service, belonging to a content rule to reach that same content rule?For example:I have a service called serv1 with IP 192.168.44.10 listening in port 8080.Another service called serv2 with IP 192.168.40.11 listening in port 8080...
I'm trying to upgrade IOS in Dual MSFC3 routing cards, currently I'm running IOS Version 12.2(17a)SX1 (quite old) and cisco sent me a document outlining step by step what to do. http://www.cisco.com/en/US/products/hw/switches/ps708/products_configura...
Hi Flavio. Thanks for the info.
Cisco did confirm that as this is not documented hence not supported.Cisco did also confirm the routing commands to configure (eigrp, ospf, bgp) do exist in the VG400 and some tests have been done with OSPF. But it is ...
I looked at feature navigator under Archives.I was able to find the VG400, and the whole feature set just comes as 1 liner saying:
WebEx calling integration for IOS XE based Voice Gateways????WebEx calling integration for IOS XE based Voice Gateways?...
Thanks for the answer Jatin.But I believe I would need the ACL already created in the ASA. I can successfully do this, but what I am really trying to accomplish is apply the filter-id not with an already created ACL in the ASA, but a Dynamic ACL mayb...
After some testing, this does not seem to be working as I expected.I am able to authenticate against the ACS, shortly after looks like an ACL is generated by the ACS and pushed down to the ASA. Looks like the generated ACL is the username. Then a bun...
Have another question I am not finding in the documentation.I have created an Authorization Profile in ACS 5.2I have put the Radius Class attribute with the name of the external group policy.Some of them group policies have 10 or more ACE in it, do I...
