Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am deploying a NAC 4.7.2 in-house to stage for a customer deployment, the deployment method I used is L2 OOB VG, I configured the switch, managed subnets, and vlan mapping. However, two problems arose:1. Arp replies from the trusted to the untruste...
We have single ospf area running over DMVPN and the number of branches keep increasing , I need help to divide ospf to muli-areas, our IP address allocated to branch offices are designed according to geographic locations.
Hi,I am trying to reproduce a scenario to implement at a customer. in short I would like to run ISIS routing over DMVPN tunnels. with much troubleshooting, I discovered that the soonest I enable tunnel mode gre multipoint the isis routing give and er...
dear Faisal,If you are asking about enable vlan re-tagging in the managed subnet form, then it is unchecked, and as per the documentation of NAS, this is a recommended setting when wireless AP roaming is used. correct me if i'm wrong but for wired de...
Dear Faisal,sorry for that mistake, Yes the ports are set to trunks it was just a typo. As for the IOS and make of the switch please find it below:Switch Ports Model SW Version SW Image ------ ----- ----- ...
Hi Faisal,OK, so in other words, there is no need for an arp entry of the subnets gateway in NAS, anyhow, I have attached a topology describing the setup done. I thank you for your time for assisting me in this matter.
Hello Faisal,Thanks a lot for your prompt response, I did restart NAS/NAM once, twice and even thrice to no avail. can you just confirm my understanding that DHCP, ARP, DNS are allowed by default without any extra traffic policies set.In other words,...
