Hope somebody could help me on this problem, I have more than 30 installation using cisco 2520 with IOS version 11.3 running to all routers, Serial port 0 is connected through WAN (Frame relay or Leased line) while the dial backup using Async modem...
While doing FTP transfer from servers located on different VLAN (Vlan 1 and VLAN 4) Data transfer will be interrupted due to communication lost between the two, I thought I lost the physical links but when I'll try to ping the other servers it respo...
Hello everyone,Showing interface status on our catalyst 6509, I've seen so many input errors (samples below), The cables are already fixed but these errors keep on incrementing. 63 runts, 0 giants, 0 throttles186 input errors, 0 CRC, 0 frame, 0 o...
On the remote router side, I configured the dial backup interface modem to backup leased line modem whenever the leased line modem goes down the dial backup works just fine, However in some of my installation I noticed that the dial backup modem goes...
Hello Everyone, I'm trying to create additional channel group in the 7206 router and here's the messages I got! %Insufficient resources to create channel group I would like to know if this is related to memory problem or is there any work around i ne...
Thanks for your reply, I'm sure the controller is not fully utilized, in fact i attached the sequence of my commands for reference, Controller 5/7 still empty, however controller 5/0 to 5/6 are already utilized but when I start to add channel group ...
Thanks,Here's what im trying to do...7200#config tEnter configuration commands, one per line. End with CNTL/Z.7200(config)#controller e1 5/77200(config-controller)#channel-group 0 timeslots 1%Insufficient resources to create channel group7200(config...
Yes I also add Ip helper address in Vlan5...The source Vlan is in Vlan6 where my pc is connected the target Vlan when telnetting is any other vlan (i can telnet 172.xx.Vlan3.255 or 172.xx.Vlan4.255) and so on...