Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a cbw 150ax wap. single wap, no extenders. i have many clients connected. i have one client that refuses to connect. it is a win11 msft surface pro 7+ running an intel wifi 6 ax201 chip. i have updated all drivers firmware for the machine and ...
i have a 150ax that boots up and connects. ssid wlan shows up and clients are connected. the led lights are stuck in green, red, off cycle. when i log into the gui, there are 0 access points (this is the only ap at the moment), there are 0 clients, b...
Something is happening during the handshake:*Dot1x_NW_MsgTask_0: Aug 04 12:53:08.759: %APF-5-CLIENT_DEAUTHENTICATE: apf_80211.c:4071 Client Deauthenticated: Client MAC: b0:60:88:8e:05:c1, Ip Address: (0.0.0.0), AP Name: AP34B8.8347.E020, Radio: 5 GHz...
i have 18 other clients connected. i do not have a password problem. i have re-entered it many times, preconfigured as known network, etc. i was chasing that clue as well and trying to figure out how to change AES / TKIP on the wlan to only allow one...
the correct way to factory reset is in the admin guide:To reset the AP or Mesh extender to factory default using the Mode button, follow the steps below.1. Remove or unplug the power to the device.2. Press and hold the Mode button while re-applying p...
for anyone who gets stuck in this same situation, there are 2 IPs that are needed for the primary AP. one for the hardware itself and another one for the management layer. once the management layer gets an IP, you can go to that IP, and you will see ...
