Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have experienced problem with Client associated with AP but not shown in the client section, and client could not get internet connection, after checking logs when issue occurred, I have found the following error messages: *apfReceiveTask: May 15 ...
Hi All,So I am running into mDNS setup issue with my Cisco CBS220 switch that is very annoying and have no idea where to start the trouble shooting. I have 2 AP connected to the Switch with trunk port enabled and a 10G uplink trunk port to my UDM. I ...
So basically I have 2 150ax connected to a CBS220, I noticed that my unifi UDM is not repeating everything through the VLAN, I thought it’s UDM’s fault. It turns out, when my laptop switch between the APs, available/discovered bonjour advertisements ...
Hi everyone,I have recent got my replacement of the faulty 150ax at my own cost and I’m experiencing difficulties setting it up. I plugged the new AP into the same port as the old AP and made sure the port configuration is in trunk mode, have access ...
Dear all,Before one of my APs fails, it keeps rebooting unexpected at a specific time. at 01:20 UTC+8, I noticed my remaining AP also does that. its seems very weird to me as I clearly did not set any automation to my APs to perform self reboot. Luck...
Hi,Sorry for the incredibly late response, because I though it might have the site not remembered when I am not joining with the “management wlan”, didn’t know that they have updated the app to be something make sense.In response to your questions, t...
Hi,So I did extensive checking with the system. The system identified AP1 as primary AP, while AP2 is the preferred primary. There is no way to see if they are registered under which AP AFAIK. right now, I have changed the preferred settings and the ...
Hi,its not accepted to use a physical WLC in the SMB product line. Both APs are 150AX, primary capable, and is also running a on board controller to control other AP. from I can tell, I did not enable optimized roaming on the 5Ghz channel, which prob...
Hi,I have tried disabling random MAC address on my WLAN. I will try disabling optimized roaming again, but it didn’t help last time I tried. The radius server works fine as well. I will try to access its lag later anyway. The quickest way to resolve ...
Hi, it’s configured as a trunk port (General) that accept all configured VLANs, both APs have no problem connecting to the VLANs. The AP have a phantom WLAN with a VLAN 20 to allow AAA to assign VLAN 20. (I did not find any ways to add a VLAN to the ...
