Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to learn about ether channel on 3 cisco switches. All switch have ether channel configured on 2 of their ports. My question is, after configuring all the switches to use ether channel on the 2 ports I have a set of ports that are "blocking...
I have two vlans (vlan 1 & 30) on a cisco C2960-L switch. I can PING from vlan 1 to vlan 30 but I can not PING any node on vlan 1 from vlan 30. Both nodes on each vlan can successfully connect to the internet. My setup from ISP/WAN to the next hop an...
This should be a very basic fix, but I can't seem to find the answer. I have a Cisco C2960-L switch & Cisco 1921 router.I have configured port gi0/16 on the switch to be the trunk port. I have two vlans (1-30). Port gi0/1 on the switch is on vlan 30....
I have searched the internet trying to find a way to do a factory reset on the
Catalyst 3560-CX switch
and I found NO luck.
I am consoled holding the "Mode" button down while switch boots and get to the "switch :" prompt. I type
flash_init
and all I ...
I figured it out! The Windows firewall was blocking ICMP. I found this out by disabling the Windows firewall on the node then running the PING command on another machine and got a successful PING. Thanks
Yes, subinterfaces worked. I guess you have to have a whole new subnet for all the different vlans. On to a new issues though, I'll create another thread for this, but how can I control the vlans from talking to each other? Basically, I can PING one...
