Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having an issue with a 1310 in root bridge with wireless clients mode. I have the bridge connected to another bridge in non-root bridge mode and everything is working fine on that end on ethernet.My issue is the wireless one the frirst bridge....
can anyone tell me if AIR-ANT2485P-R would be compatible with AIR-AP1020-a-k9. Just trying to piece some older parts together to make a quick WLAN.Thanks.
Currently all traffic is sent through the mpls network back to corporate for internet. Added a cable modem for internet to the second interface and trying to send all internet traffic through this interface. I tried changing the gateway to point to ...
Hopefully this will be an easy solution for some of you.I have two LAP1041N APs I am trying to setup on a new 2100 WLC (7.0.116.0). THe APs will blink green fast; then go to a green, red, blue cycle for a min or so; then back to blinking green fast....
Currently my users gateway goes to a 3750 core switch, which then routes to a 2900 series where the 2nd interface resides. The gateway of last resort on the 2900 is currently: 0.0.0.0/0 [20/0] via 192.1.4.1 which is the mpls circuit.Should i not ch...
I went back and checked the settings, the other network guy was trying to get a new subnet going just for wireless. He did not have all of the routes setup yet. I reset everything back to our basic network settings and radios came in fine. Ill ge...
