Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a configuration on BGP that requires for 5 Neighbors 4 locally (same switch) and on that is at the end of a serial link, my question is does the neighbor need to directly connected or can I route the BGP information across the serial link and ...
We have just recently aquired a 515 and have loaded the latest code rev's for ios and PDM however on the bench the laptop we are connecting to the inside does not run up PDM it just shows page cannot be displayed. we have used the default wizard to s...
Has anyone seen a situation where a PIX 515 primary locks up with the above error code and doesnt switch to secondary. what is the cause of this error code.Many thanksIan
I need advice on the best way to stop a DoS against my border router, we are experiencing small and medium buffer overflows which then cause a bus error and the router reboots. If anyone has seen this befor can they point me in the right direction.Ma...
Many thanks however that did not help, what is the least amount of config required to get the pix pdm working as I can blow the config down to it's least.Cheers
I have one ISP who provides me with multiple links, to allow me to loadshare I use BGP with metrics, this allows BGP to pick the best routes out and our architects to decide inbound balencing across our IP range. here is an example config. hope it he...
had a similar problem the best info I got was from the following link javascript:newWin('http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_v52/config/examples.htm#xtocid7') If the link does'nt work then my problem was on the site as "cro...
