About broberto82

broberto82 · 02-26-2020

Hi,with your precious help I configured my ISR 1113-8p router. Below I post my actual running.config.The point now is that I should be able to reach some of my LAN internal resources with my public (dynamic, ISP provided) IP address: this is because ...

broberto82 · 02-05-2020

Hi,I would need some help with a NAT problem.With some previous help from this community I configured a Cisco ISR 1113-8p, but I cannot allow users from outside my LAN to access to some hosts inside my LAN. They're getting a "connection refused". mes...

broberto82 · 02-03-2020

Hi,I'm a newbie trying to configure my new Cisco isr C1113-8p for my network.I set up my running-config and my router can navigate, but I'm getting some strange behaviours... and I'm sure they're related to something wrong on my routing configuration...

broberto82 · 02-01-2020

Hi everybody,I'm trying to configure my Cisco 1113 to work with italian TIM Vdsl2 FTTC. Unfortunatly it doesn't work and I'm trying to find where the problem is.First of all, here are the requirements of the ISP (TIM):- Vdsl2 with spectrum between 8b...

broberto82 · 01-24-2020

Hi everybody,I just purchased a new RV134W for my home. I have to manage serveral devices on my LAN, such as IP cameras, VoIP phones and some clients.Everything seems to work fine except for some stucks on the net. Checking the router's log I get a h...

broberto82 · 02-29-2020

Hi,and thank you for your patience.I tried Georg's solution with particular attention on the source list name, but unfortunately it didn't work. I also tried what Paul suggested in the OP he linked, but I ended to the same result, since I had to cons...

broberto82 · 02-28-2020

Hi,sorry it took me so long to reply, but I can do tests just when my clients aren't using the net.I tried the configuration, but unfortunately it didn't work... all my clients couldn't access the Internet. During the test I also checked that accessi...

broberto82 · 02-26-2020

Hi Georg,and thanks for yor reply. I tried to follow your advices but unfortunately the problem seems to be the "ip nat source" command, since when I try to type it I get the following error:Router(config)#$ce static udp 192.168.178.200 8002 interfac...

broberto82 · 02-11-2020

Hi Paul,with pleasure I rated your post. Thanks again.Kind regards,Roberto

broberto82 · 02-10-2020

It works, guys!!!Thank you very much for your support!!...and just to share with you a feedback information: the "ip nat inside" under the sub-interface is useful for the VoIP communication: if I try to replace it with "ip nat outside" I get one-side...

Member Since	‎01-22-2020 02:28 AM
Date Last Visited	‎02-29-2020 07:13 AM
Posts	21

User Statistics

User Activity

Accessing inside LAN resources with their public IP

Allow access to LAN hosts from outside the LAN

Routing problems on 1100 Isr

Cisco ISR 1113 and Vdsl2 TIM configuration

RV134W - warm nf_conntrack: table full, dropping packet.

Re: Accessing inside LAN resources with their public IP

Re: Accessing inside LAN resources with their public IP

Re: Accessing inside LAN resources with their public IP

Re: Allow access to LAN hosts from outside the LAN

Re: Allow access to LAN hosts from outside the LAN