Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,We have a requirement where we need to use SNMP for monitoring of the controller, But as a security measure we would want to stop the SNMP device access.I am aware there are some CPU based ACL's we can use to block SNMP device access.Can anyb...
Hi Team,This is with respect to QoS configurations on DMVPN headend router.Noticed that the child policy is configured but not called under the parent-policy. Will there be any errors or service impact when correct the configurations? Current Config:...
I have a 5508 WLC which is in HA. The current show boot gives below output(anhv4-01sr-wlc-02) >show bootPrimary Boot Image............................... 8.3.143.0Backup Boot Image................................ 8.5.161.0 (default) (active)My questi...
Hi Team,Need your inputs on the below query. I need to upgrade the code on 3504 in HA mode to 8.5.161 from 8.5.135.Please ensure if the steps below are good to upgrade code without breaking the HA.1. Save current config. Copy the 8.5.161 image from T...
Hi Team, I have 2 setups that need a code upgrade.Two 3504 in HA systemTwo 5508 in HA system. I have some questions on code upgrade in HA mode:1. As far as I understand you have to perform upgrade only on the primary and the second one will be automa...
I need to retain 8.5.161. Is there any command to swap the primary and backup images. Is there are any option to make 8.5.161 my primary image and 8.3.143 the backup image?
Hi Leo,Sorry that was just a example I took. But my actual query is as per my understanding at any point of time a WLC can have only 2 images. When a new image is copied the current primary becomes backup and the new image becomes primary. Now in the...
Hi Balaji, Thanks for looking into this. But my query is, as per my understanding at any point of time a WLC can have only 2 images. When a new image is copied the current primary becomes backup and the new image becomes primary. Now in the output be...
