Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have a pair of cisco 9300 which were setup by a 3rd party and i need to create a new Vlan and want to create a new HSRP stanby IP, but to create the stanby IP i need to set the HSRP version when configuring the vlan, but i dont know if it's...
Hi All,I'm new to Cisco AP's and i'm having a bit of bother with a new Cisco 2802E AP. I'm using this AP as the central controller and as the DHCP Server for the network that they sit on. So the DHCP side of it is working fine, but it's handing out...
Hi all, New to the forum and looking for some help setting up and configuring a Cisco AP. So, I bought a AIR-AP2802E-E-K9C, well it says that on the outer box but the sticker on the AP actually says its a AIR-AP2802E-E-K9 model.So i watched a few you...
Hi Paul, Many thanks for the quick reply - I was going to raise a proper support ticket, but not sure if they cover general configuration enquiries. So looking at the output of the Sh Standby i can see there appears to be associated HSRP group names...
Hi Scott,Just using the DHCP functionality built into the Cisco Air-2802E access point. which allows a whitelist and a blacklist, but it's a bit glitchy in that the whitelist is a bit pointless as it will hand out DHCP irrespective of a device Mac a...
Hi Scott,When you say create an exclusion - Are you assuming that i'm using a Windows / linux based DHCP server, as currently i'm just using the built in DHCP server on the AP controller. It's a long story but on our plant IT side of things, everythi...
Hi Scott Thanks for the quick response and your help. I can't see anywhere you define an exclusion, the only other option i can see is to create a blacklist. Where do i find the exclusion settings ?
Hi Scott,I understand what you are saying about putting the AP's in their own management VLan for the purposes of provisioning which makes sense, then create a DHCP scope for the AP's with MAC Address filtering. I suppose i could then Tag other vlans...
