PGW & 5400 bearer configure

[hsalama_us]

we had successfully configure PGW+SLT2651XM+L.Switch, L.Switch & PGW can communicate[rtrv-tc:all, shows active cic].

SLT uses drop/insert, and it is configured to supply a trunk [E1] to AS5400

We need to configure signalling bet. PGW and 5400AS box.

1-as you know there are many implemenation, so i want to know which best fit the mentioned solution

2- if i choose to use PGW in signalling mode, should AS have a PRI E1 [not CAS]

3- in case of nailed [call control] configuration in the 5400 side

[teodor.dobrev]

Hi,

It is not very clear what exactly is the solution.What you want to do is not understandable with just showing the connected devices.

And signaling mode and nailed mode are the same thing.

You can eiter configure PGW in signaling (just translate SS7 to IP signalisation) or in Call Controll mode.

Please provide more info to get an answer.

Best Regards,

Teo

[hsalama_us]

really i want to configure the signalling bet. PGW and AS5400 [PGW side and AS site]. any detailed info you need, i will provide, please just ask.

attached SLT configuration