Cisco IP Phones - Ring order
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-22-2015 07:59 AM - edited 03-21-2019 08:43 AM
I'm not sure what topic this goes under, so forgive me if it's in the wrong section. We have a group of 11 phones and I'd like to set it so one phone starts ringing immediately followed by the remaining phones on the second ring.
We have Cisco Configuration Assistant software, so I would assume I have to do the changes on there, I just can't find the right section or the right wording.
- Labels:
-
Voice Systems
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-09-2015 01:01 PM
It's not the phone but PBX/call manager job. So ask your local PBX/call manager administrator; or ask in community dedicated to equipment your phones are connected to.
