Cisco SPA303 hot line support
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2011 02:06 PM - edited 03-21-2019 04:21 AM
Hi Guys
We are wanting to configure a pair of Cisco SPA303s to support hot line functionality. I.E. When the phone goes offhook, it immediately dials a particular number without the user having to press any buttons. We are using SIP as the signalling protocol.
According to the datasheet, this is possible (perhaps only for SCCP though?):
http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps10998/data_sheet_c78-601648.pdf
However, I can't figure out how to do it. I have scoured the phone and web interface options and can't find anything. I have also checked the XML configuration template for the SPA30X and 50X phones. I can't figure out which option allows me to do this.
Has anyone else done this before? Would they mind sharing how they did it?
I have tried searching these forums and Google to no avail. If I've missed something, please point me in the right direction.
Thanks a ton!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2011 03:08 PM
Hi,
Go to the web page of the phone. Each line under the SPA has a Dial-Plan option. You just need to paste the next code in order to do the PLAR (HotLine).
(P1<:extesion> | (9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx)
PX=Pause for X second.
extension= where you want to auto dial.
In my case
(P1<:2002> | (9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx)
the phone automatically call to extension 2002
