Hi,
I'm looking for some help to configure pick up and group pick up with programmable features buttons (not available with soft key button if i understand) by CLI: i can't use Cisco Unified Communications Manager administration.
I set the dn and add it the pick-up group . Then i create a template and assign it to the register pool of my phone .
Below, the configuration i try to set for a 8961 sip phone.
voice register dn 3
number 2044
call-forward b2bua all 5000
call-forward b2bua busy 2099
call-forward b2bua noan 2040 timeout 20
call-forward b2bua unregistered 2099
pickup-group 1
name thomas
no-reg
label thomas
!
voice register template 1
feature-button 1 NewCall
feature-button 2 Cfwdall
feature-button 3 Redial
feature-button 4 GpickUp
softkeys idle Gpickup Pickup
!
UC_540(config)#do sh voice register pool 3
Pool Tag 3
Config:
Mac address is D824.BDBA.0EE2
Type is 8961
Number list 1 : DN 3
Proxy Ip address is 0.0.0.0
Current Phone load version is Cisco-CP8961/9.2.1
DTMF Relay is enabled, rtp-nte
Call Waiting is enabled
DnD is disabled
Video is disabled
Camera is disabled
Busy trigger per button value is 0
speed-dial 1 2045 label 2045
speed-dial 2 2042 label 2042
speed-dial 3 2041 label 2041
feature-button 4 GpickUp
keep-conference is enabled
registration expires timer max is 600 and min is 60
username XXXX password XXXX
template is 1
kpml signal is enabled
Lpcor Type is none
Transport type is tcp
service-control mechanism is supported
registration Call ID is d824bdba-0ee20002-2a60e3bc-29be0a44@10.10.78.17
Registration method: bulk - completed
Privacy feature is not configured.
Privacy button is disabled
active primary line is: 2044
contact IP address: 10.10.78.17 port 49718
Phone SIS Version: 5.1.0
GW SIS Version: 1.0.0
Dialpeers created:
Dial-peers for Pool 3:
dial-peer voice 40003 voip
destination-pattern 2044
session target ipv4:10.10.78.17:49718
session protocol sipv2
dtmf-relay rtp-nte
digit collect kpml
codec g711ulaw bytes 160
call-fwd-busy 2099
call-fwd-noan-timeou 20
call-fwd-noan 2040
call-fwd-all 5000
after-hours-exempt FALSE
When i reload the phone i can't see the new features
Looking for some help to see what i forget ?
Thanks you.