copying setting parameters ATA SPA112

[nicolunardi1]

Hi, I would like to export settings of my ATA, but I don't find such a function on the menu. Should I have this log, I could send the data to my provider, as I am not receiving phone calls (but I can call). Wizard inside VOICE/SIP cannot be copied/pasted indeed.

Thanks.

Firmware Version:

1.4.1 (002) Oct 26 2015

[Jaime Valencia]

SPA endpoints are supported in the SMB community, might want to move your thread over there.

[nicolunardi1]

Gracias Jaime, esto forum para mi es realmente un labirinto.

[Dan Lukes]

If you prefer Spanish you should consider to ask in Soporte a empresas pequeñas instead.

I would like to export settings of my ATA

Read Retrieving SPA112 & SPA122 Configuration URL

I am not receiving phone calls (but I can call).

Most of time either NAT/firewall issue or you SPA112 is not properly registered to provider (no attempt to register at all, or registration rejected by provider).

[nicolunardi1]

Hi Dan, with my spanish answer to jaime I just wanted to thank him warmly.

I originally use to receive phone calls, but, suddenly it doesn't work anymore. I change no settings.

I followed this link of yours  SPA IP Phone: Extracting Configuration with spacfg.xml

and it works.

I made also a big mistake in the thread you sugested me, sorry. I clicked "report" and now it is not possible to "unreport". This is the result [code]Bad token. You seem to have followed an invalid link[/code]

[Dan Lukes]

Glad to hear you saved configuration successfully.

According "unreport" - just reload page and try again. I tried it, it should work.

[nicolunardi1]

Works. thanks again and sorry for the inconvenience

[Dan Lukes]

No problem. You may consider to rate comments according your wishes - it may help others ti discover valuable answers.