Outbound CLID control

[romanrodichev@iementor.com]

On UC500, I have a SIP trunk to the PSTN. In the SIP trunk configuration, it asked me to specify the main number for outbound CLID, and I can see that "Register Caller ID Main Number" is checked.

I want the following flexibility, how do I achieve it in CCA? Is my only choice CLI?

1. I want outgoing calls to 911 to have the same main CLID

2. I want outgoing calls to all other number to have DID CLID

I'm aware of the Telephony > Dial Plan > Outgoing > Caller ID page, but I don't see ability to set the callerid based on the destination number.

[Darren DeCroock]

Hello,

This cannot be done in CCA, (At least there is no way that I can think of.)  only through CLI, by changing the translation rules on the outgoing 911 dial-peer.

Thank you,

Darren