02-16-2011 09:54 AM - edited 03-21-2019 03:41 AM
My SPA525G2 phones keep stating its refreshing Voice Component.
It keeps doing this over and over.
I have enabled syslog debuging and note that it states:
"request reboot type=16 reason=16"
What does this mean and why perhaps might my phone be refreshing all the time?
The file I am using to provision these phones with is something we have been working on below:
http://www.provisioner.net/user_uploads/1297815425-data.txt
Pretty basic XML file.
02-17-2011 03:37 PM
Hello, Echo...Echo...Echooo
Bump
02-17-2011 09:19 PM
Hi Kevin
Seems that you need to adjust your code as sentence "{$line}" is not working as you spected in this block:
{line_loop}
{/line_loop}
xml file is not readable due this, but rest of the file is good.
Regards,
Rogelio V.
02-18-2011 07:09 AM
Alas, a reply thank you I will look at this, meanwhile where do I find the documet for these codes:
"request reboot type=16 reason=16"
02-18-2011 07:40 AM
Take a look on this, also applies for phones:
https://supportforums.cisco.com/docs/DOC-9889
0x00000016 parameter mismatch [example you are changing a parameter that should not be changed such as MWI]
Rogelio V.
02-18-2011 09:13 AM
Super thank you, So as to this XML file I am not sure how to go around this..
This is a variable that is assigned by my provisioner system, what would you recommend on how to prevent the XML from reading this variable as an invalid section?
02-18-2011 09:22 AM
Wait a minute... Your assuming that this XML is what the phone is actually reading.. Thats not correct.
Our Provisioning system builds the xml for each phone:
Example of the output the phone sees:
02-22-2011 08:24 PM
Kevin
Thanks for share your files, this issue is related to Resync_Periodic timer, it is set to 60 secs.
resync typically takes place when the voice lines are idle. In case a voice line
is active when a resync is due, the IP Telephony Device delays the resync
procedure until the line becomes idle again.
However, it waits no longer than
Forced_Resync_Delay 14400 secs by default.
Have you set to 60 for any special reason?
Regards
Rogelio V.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide