Hi There,
i have a scenario : Cisco UC560 connected to 7965G and 7975 IP Phones. In my UC 560 system clock as follows:
UC560X#show clock
14:18:11.456 GMT Tue Jul 17 2012
UC560X#service-module i0/0 se
Trying 10.1.10.2, 2002 ... Open
se-10-1-10-1#
se-10-1-10-1# show clock
14:18:29.157 GST Tue Jul 17 2012
UC560#sh ntp status
Clock is synchronized, stratum 3, reference is 18.7.21.144
nominal freq is 250.0000 Hz, actual freq is 249.9992 Hz, precision is 2**28
reference time is D3AFBAA7.D0452C16 (14:19:19.813 GMT Tue Jul 17 2012)
clock offset is 24.5711 msec, root delay is 208.40 msec
root dispersion is 40.74 msec, peer dispersion is 1.18 msec
loopfilter state is 'CTRL' (Normal Controlled Loop), drift is 0.000002907 s/s
system poll interval is 64, last update was 60 sec ago.
Here the problem which is facing : Cisco 7975G show time 10:22 (though the current time is 14:22 ,we are located at GMT +4) and current time 7965 : 15 :24 (1 hour more)
I have gone through all the the possible clock settings make things done. i am afraid to see that when console notification messages follows the time of 7975 ip phones .
Please revert back if anyone have any suggestions.
