Good Day.
I am pretty new to configuring voice systems, so fogive me if I am asking the obvious. I currently have the following hardware/software:
- UC520-32U-8FXO-K9
- SW-UC520-4.1.0
- IP Phones - SPA502G, SPA504G, SPA508G, SPA509G
- CCA 2.2(5)
I believe that there are some compatibility issues using this version of CCA with the UC520-4.1.
Additionally, I tried using CLI to configure the UC520, but had issues loading the SPA50X firmware for the phones - only saw 521G loads when I applied the spa50x-30x-746 firmware.
Please advise about the necessary steps I should take to have this solution working.
Thanks & Regards