10-26-2015 12:51 PM - edited 03-21-2019 10:29 AM
Hello,
I've just finished the configuration and turned the management interface from http to https.
After that I don't get any webconfig answer anymore (website not available).
A portscan gives me open ports: 22, 443, 2869 and 49152.
Is there any way to get the webconfig back beside a complete factory reset?
Thank you.
10-27-2015 05:52 AM
This helped: https://supportforums.cisco.com/discussion/12532131/spa112-not-able-enter-webinterface
Well, well: I found an old opera browser somewhere and I could connect.
Will this be fixed in a future firmware release?
10-27-2015 06:15 AM
Only Cisco knows. But no Cisco's developer is reading this community. Call SMB support center and complain if you wish to make Cisco aware of the issue. But even in such case don't expect fast solution.
10-27-2015 08:06 AM
Thank you for the suggestion. I had a chat with SMB support and they opened a ticket.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide