CISCO SPA514G program main screen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2017 09:12 AM - edited 03-21-2019 09:05 AM
How do I program the screen/line buttons to the right?
It just shows the extension number on all 4 line buttons.
I have gone through the entire user manual and do not see how to do this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2017 10:05 AM
User Guide is for end user using the phone configured already.
If you wish to configure the phone, you are phone administrator. As administrator, you should follow Administration Guide instead.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2017 12:56 PM
Thanks for responding - however it appears that I need an admin login of which I do not have and I do not have an attendant phone. All of which may be way over my head!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-17-2017 04:05 PM
Attendant phone (whatever you mean by it) will not help you.
Assuming the default phone's admin password has been replaced by another one ...
Either
- you are phone administrator - then reset phone to factory default and configure it from scratch (including new password)
- you are not phone administrator - then call such administrator, he make changes for you
