Hello everyone.
Help solve the problem.
There are two switches of 3850 connected to the stack.
Connection via the console line 0, using the console cable.
The command "sh run" displays not all the configuration but only the first part.
Other commands also print only the first part of the configuration.
After reading this document "https://www.cisco.com/c/en/us/support/docs/routers/asr-1000-series-aggregation-services-routers/212149-Configure-IOS-XE-to-display-full-show-ru.html" came to the conclusion that the problem in the "privilege level"
Help solve an incomplete configuration problem
core_SW#sh run
sh run
Building configuration...
Current configuration : 8370 bytes
!
!
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
service compress-config
!
hostname core_SW
!
boot-start-marker
boot-end-marker
!
!
vrf definition Mgmt-vrf
!
address-family ipv4
exit-address-family
!
core_SW#
core_SW#sh privilege
sh privilege
Current privilege level is 15
SW№1 via console
core_SW#sh switch
sh switch
Switch/Stack Mac Address :
Mac persistency wait time: Indefinite
H/W Current
Switch# Role Mac Address Priority Version State
------------------------------------------------------------
1 Standby 1 V02 Ready
*2 Active 2 V02 Ready
SW№2 via console
core_SW>en
en
Password:
% Access denied
core_SW>