active/standby failover and VPN replication

[mahesh18]

 Hi Everyone,

If ASA is config as Active/Standby failover.

If Active ASA has VPN image,profile and plug-ins will this will also replicate to standby ASA?

or I have to manually do this on standby ASA?

Regards

MAhesh

[Marius Gunnerud · Accepted solution]

The VPN image and profile are not replicated, you will need to do this manually.  Here is a list of what is replicated in a stateful Active/Standby setup:

• The NAT translation table

• The TCP connection states

• The UDP connection states

• The ARP table

• The Layer 2 bridge table (when it runs in the transparent firewall mode)

• The HTTP connection states (if HTTP replication is enabled)

• The ISAKMP and IPSec SA table

• The GTP PDP connection database

 --

Please remember to rate and select a correct answer

[mahesh18]

Many thanks

MAhesh