We are trying to bring up a L2L VPN to a vendor. The vendor's IP addresses overlap with one of our internal subnets. The vendor claims that they cannot apply a NAT on their side. Is there a way to configure NAT on my side to NAT the remote host? I tried creating a static entry
static (inside,outside) globalIP localIP subnet
The NAT seems to work, at least according to the xlate table, but I cannot bring up the tunnel.
1) will this actually work?
2) how should I define "interesting" traffic? Using the remote NAT or the remote real IP?
Are you responsible for risk management, compliance management and auditing of a network?
If so, we’d like to speak with you to learn your current processes of enforcing compliance and managing risk to help us develop services that will ...
Once you've expanded Cisco Secure Endpoint connector deployment to about 50% of your licensed count (check out this article that shows you how to do that), it's time to put those connectors to action i.e. convert them to Protect from Audit mode for vari...
Hello! I’m Betsy, UX Researcher, on the Cisco+ Secure Connect Now team. Nice to meet you all .We have a short survey to learn about your Zero Trust Network Access (ZTNA) journey. Whether you have, plan to, or have not implemented a ...
A set of interface access rules can cause the Cisco Adaptive Security Appliance to permit or deny a designated host to access another particular host with a specific network application (service). When there is only one client, one host and one se...
How To: Cisco ISE Captive Portals with Aruba Wireless
Authors: Adam Hollifield, Brad Johnson
IntroductionPrerequisitesMinimum RequirementsComponents UsedConfigurationAruba Wireless ControllerWLAN CreationAuthentication ConfigurationRole & Policy Confi...