AnyConnect Client Profile in ASDM

[Marius Gunnerud]

I am trying to configure a client profile under the AnyConnect Client Profile tab in the ASDM but keep getting an error message stating "Check that you have a proper AnyConnect package installed in the AnyConnect Client Software menu.  Also check that your ASDM username have enough privelege."

My user has sufficient privilege but I am not sure which AnyConnect software I should have to enable this.  Righ now I have

anyconnect-win-3.0.10055-k9.pkg installed.

This is a lab setup using GNS3.

Any ideas?

[Javier Portuguez]

Hi Marius,

I would assume you are running ASA 8.0x, right?

Please check this out:

"If you wish to use the ASDM-integrated Profile Editor to configure any of AnyConnect's components, you must use ASDM version 6.4(1) or later."

Security Appliance Software Requirements

So at this point, I would suggest to try to upgrade your ASDM to 6.4 or try with AnyConnect 2.5.

Let me know.

Thanks.

Portu

Please rate any posts you find helpful.