Anyconnect connects properly but no mapped drive

[karlmernagh]

Hi all,

I'm new to this and I have installed and configured Anyconnect 3.1. It connects perfectly to the vpn server and the credentils are fine but I donot see a mapped drive in Windows 7. Is this notwhat is supposed to happen or do I have to do this manually? If someone could point me to a tutorial or give me ome advice on this I would be most grateful.

Kind Regards

Karl

[fb_webuser · Accepted solution]

configure SBL (start before logon)

http://its.uncg.edu/network_services/vpn/client/windows/

---

Posted by WebUser Erik Boss from Cisco Support Community App

[karlmernagh]

Thank you Erik for getting back to me so quickly. Such a learning curve over a few days but it will beworth it in the end.

Kind Regards

Karl