Hi everyone, i have challenge. I have an small office network, 192.168.0.0/24.
There's a ASA setup there, Anyconnect is enabled on it.
Anyconnect runs full tunnel, no local LAN access.
RA pool is 172.30.0.0/24.
NAT exemptions is in place, overload is in place.
The problem is, if an employee sits at home, gets the IP 192.168.0.5 from his local router. Connects to the office VPN successfully, but can't reach his fileserver, which so happen to have 192.168.0.5, the same as the IP on his local NIC.
Windows prefers the local /32 route on the local NIC compared to the default route on the VPN adapter. I could ask him to change to subnet at the office, or at home. But does anyone have the experience with this kind of duplicate IP's?
/Bo
