anyconnect reconnecting with Cisco rv340

[harshakhegde]

Hi,

I recently bought a rv340 for my home and I have two ISP connection. I see that my Cisco Anyconnect VPN connection keeps reconnecting when the RV 340 is in the loadbancer mode.

regards,

Harsha

[balaji.bandi]

May be i woould not advised to LB for the VPN Connection. (use 1 ISP as Primary as default). see how is that stability ?

how are you LB ISP, using DNS ?

[harshakhegde]

With primary and secondary it works ok, but defeats the purpose of active loadbalancing. 

[balaji.bandi]

how are you doing LB ? explain more.

[nagrajk1969]

Hi

Can you try the below and check (with the router configured in load-balance mode)

- Under WAN/Multi-WAN\Interface-settings table, edit for WAN1 (and also WAN2 next) and set the "Network Service Detection" setting to "Remote Host: 8.8.8.8" instead of the default setting of "Default Gateway"

- Do this for both wan1 and wan2 interfaces, apply and do a permanent-save AND i would suggest to reboot the router atleast once

If you have already configured as above and still see the disconnections, then there is some other cause for it