Anyconnect Through Port Forwarding

[Abdulraouf Omar Mohamed Zenbil]

Hi !!

I Have Public IP Put Not Dedicated ( Only PPP ), Now Connected My Internet ( Ubiquiti M5 400 > Cisco ASA 5510 ) And Configured Internet Access in My Cisco ASA and Configured Any Connect Package + Anyconnect Software And I Tried it. But Not Running Because My Public IP Not Dedicated, Do you Have Any Idea About The Possibility of Running Any Connect Through The Port forwarding ? 

[Karsten Iwen]

AnyConnect will work through Port-Forwarding. I would use the following approach:

• Capture the traffic on the ASA outside interface and try to connect with AnyConnect.
  • If you see the AnyConnect traffic, your ASA config is likely wrong.
  • If you don't see the traffic, your Port-Forwarding is likely wrong.

[Abdulraouf Omar Mohamed Zenbil]

 Dear Karsten !

This work is required of me as soon as possible, I tried a lot but it does not work, in fact I do not have enough experience with VPN .

Can you give me a scenario or lab for it ?