As5300 SIMMs

[ekeen]

I have upgraded the SIMMs on my As5300 there are 3 SIMMs slots and by accident I also upgraded the SIMM for the rxboot. Everything runs fine but I need to put the original SIMM back into the slot for the rxboot.

Does anyone know if I'm going to have to reload the IOS? I really don't know here the rxboot gets its boot helper image from? I'm afraid that when I change it back from 16Mb to 8Mb I will have to reload everything?

TIA

[Georg Pauwen]

Hello,

replacing the SIMMs and the rxboot SIMM requires powering off the device anyway, so this would always involve an IOS reload.

Check the following document:

Cisco AS5300 Chassis Installation Guide

Replacing Memory Chips

http://www.cisco.com/en/US/products/hw/univgate/ps501/products_installation_guide_chapter09186a008007c707.html

HTH,

GP