Good Afternoon,
Ok, so let me start out by saying that I am by no means an expert with an ASA/ASDM but what I am trying to accomplish seems pretty straight forward and I feel like I am missing something easy!
----Internet----
eth0
1.2.3.250 = VPN termination point (This is tested and functioning properly with 10.200.1.2 as the remoteip)
eth1
10.200.1.1 Interface Address
Host IP
10.200.1.2
Issues:
The IPSEC SA is established however I cannot reach the 10.200.1.2 host
The 10.200.1.2 host cannot ping the 1.2.3.250 interface nor do i see any hits on the policy log (10.200.1.2 any ip permit)
I understand both routes are directly connected but it seems like the public and private interfaces cannot communicate
Objectives:
1. Configure the ASA so that the VPN terminating can access the 10.200.1.2 host.
2. Configure the ASA so that the 10.200.1.2 host can reach the Internet.
Is there a sample configuration I could look at of someone accomplishing a similar task?