11-30-2009 01:44 PM - edited 02-21-2020 04:24 PM
Can somebody point me to an example that sets up AnyConnect on the ASA INSIDE interface please?
I have AnyConnect working to our ASA outside interface without problems but am somehow missing a key step/difference in getting it working on the inside interface. Thanks!
12-01-2009 07:55 AM
how about an example of what the nat0 statement should look like for AnyConnect on the inside interface? I think that's where I'm
not getting it right...
12-01-2009 03:31 PM
Mark
I have AnyConnect working on both the outside and the inside interface of ASA. I do not have any nat0 statement. I do have this:
webvpn
enable outside
enable inside
Do you have enable inside as well as enable outside under webvpn?
If that is not the issue it might be helpful if you would post the config so we can see what is going on.
HTH
Rick
12-02-2009 12:59 PM
this fixed my problem w/ AnyConnect on the inside interface:
same−security−traffic permit intra−interface
12-03-2009 05:35 AM
Mark
I am glad that you got it worked out. Thank you for posting back to the forum indicating that the problem was solved and what the solution is. It helps make the forum more useful when people can read about a problem and can read what successfully resolved the problem.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide