BRI

[cisco_trouble]

People,

Troubleshooting isdn basic rates, any idea why a second bearer channel would not want to come up?

Checked the dial strings and config...cant see anything wrong..any suggestions?

Thanx in advanced.

[erniedavis]

You may want to verify the following commands in your configuration to bring both bearer channels up (these are entered in the interface command):

ppp multilink

dialer load-threshold load [outbound | inbound | either]

Hope this helps.

[cisco_trouble]

yes, this is the 1st thing i checked, configs are correct. And on the telco side, what possible problems? Layer 2 comes up, but get a bearer channel error. 1st channel comes up.

[spremkumar]

Hi

If possible can you post out the config as well as the exact error logs available out there.

regds