07-22-2015 08:50 AM - edited 02-21-2020 08:21 PM
Hi I am trying to configure Anyconnect VPN clientless based on below Cisco documents. There are a command as below. When I typed "url-list", I cannot enter it.
Here is Cisco example:
webvpn
enable outside
url-list ServerList "WSHAWLAP" cifs://10.2.2.2 1
url-list ServerList "FOCUS_SRV_1" https://10.2.2.3 2
url-list ServerList "FOCUS_SRV_2" http://10.2.2.4 3
Here is my ASA:
VPNFW-70/pri/act(config-webvpn)# url-?
configure mode commands/options:
url-block url-cache url-server
My ASA does not have url-list choice when typing "?"
Anyone can give me some suggestions? Thank you.
Solved! Go to Solution.
07-22-2015 08:56 PM
Hello,
In the 7.x code all clientless customization was included in the running configuration.
However,referencing this cisco document :- http://goo.gl/XRkrcO, you can see that this command was deprecated in 8.X ASA codes.
So the best way to configure bookmarks will be using the ASDM or create them on a server and then bring import them to ASA.
Why we can not create bookmarks via CLI ?
With the introduction of 8.x many more options were added allowing for greater flexibility. Since these new options would make the running configuration unmanagable, as a result they were moved to separate xml files. In effect this removed the capability of configuring a bookmark list via the CLI.
For more information on this discussion , please reference this thread:-
https://supportforums.cisco.com/discussion/11010546/how-do-i-create-url-bookmark-webvpn-portal-cli
Regards,
Dinesh Moudgil
P.S. Please rate helpful posts.
07-22-2015 08:56 PM
Hello,
In the 7.x code all clientless customization was included in the running configuration.
However,referencing this cisco document :- http://goo.gl/XRkrcO, you can see that this command was deprecated in 8.X ASA codes.
So the best way to configure bookmarks will be using the ASDM or create them on a server and then bring import them to ASA.
Why we can not create bookmarks via CLI ?
With the introduction of 8.x many more options were added allowing for greater flexibility. Since these new options would make the running configuration unmanagable, as a result they were moved to separate xml files. In effect this removed the capability of configuring a bookmark list via the CLI.
For more information on this discussion , please reference this thread:-
https://supportforums.cisco.com/discussion/11010546/how-do-i-create-url-bookmark-webvpn-portal-cli
Regards,
Dinesh Moudgil
P.S. Please rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide