06-17-2003 10:37 PM - edited 02-21-2020 12:37 PM
Hi All,
Can I use to pix for VPN with just 1 static IP as follow:
LAN-A------PIX1-------INTERNET---------PIX2-------LAN-B
Just PIX1 has static IP, PIX2 use DHCP from ISP. I have config this type of VPN with another brand equipment. But use PIX, I just have config VPN with both ends have static IP and I can not find information in the web site. Because when config site-to-site VPN, I should use "set peer"command.
Can anybody tell me how can I do it with PIX? Thank You!
Best Regards
Teru Lei
Solved! Go to Solution.
06-19-2003 12:57 AM
You jsut need to configure a dynamic crypto map on PIX 1, and a standard crypto map with a "set peer" on PIX 2. Here's a sample config:
http://www.cisco.com/warp/public/110/dynamicpix.html
Note that this also has VPN clients connecting into PIX 1 (Lion), so just forget about all the "vpngroup" commands you see in its configuration cause they're not needed for your scenario.
06-19-2003 12:57 AM
You jsut need to configure a dynamic crypto map on PIX 1, and a standard crypto map with a "set peer" on PIX 2. Here's a sample config:
http://www.cisco.com/warp/public/110/dynamicpix.html
Note that this also has VPN clients connecting into PIX 1 (Lion), so just forget about all the "vpngroup" commands you see in its configuration cause they're not needed for your scenario.
06-19-2003 06:27 PM
Thank You very much!
Best Regards
Teru Lei
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide