cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
146
Views
0
Helpful
1
Replies
Adam Hudson
Beginner

Cannot access HTTPS or HTTP sites through EasyVPN site to site tunnel

Having the same issue as this question: https://supportforums.cisco.com/discussion/11001836/site-site-ipsec-vpn-problem-while-access-http-traffic

Using a 5506 set up with an EasyVPN site to site tunnel. I'm guessing it's an issue with something on the inspect protocol list but nothing is jumping out at me. Here's my inspect list:

policy-map type inspect dns preset_dns_map
 parameters
  message-length maximum client auto
  message-length maximum 512
policy-map global_policy
 class inspection_default
  inspect dns preset_dns_map
  inspect ftp
  inspect h323 h225
  inspect h323 ras
  inspect rsh
  inspect rtsp
  inspect sqlnet
  inspect skinny
  inspect sunrpc
  inspect xdmcp
  inspect sip
  inspect netbios
  inspect tftp
  inspect ip-options

Any comments are appreciated.

1 REPLY 1
Aditya Ganjoo
Cisco Employee

Hi Adam,

Can you share the packet tracer for the concerned traffic ( use port 80/443 for the destination) ?

Also can you check the DNS settings of the clients who are trying to access these services ?

Regards,

Aditya

Please rate helpful posts and mark correct answers.

Content for Community-Ad