Channelized E1 Dial Out Configuration....!

[d.majumdar]

Hi,

Hv tried searching a sample config, but didn't find any thing specifc as such. Looking for a PRI dial out config with NM-30DM to connect to 100 plus remote sites which will hv both ISDN & PSTN.

An early response is highly appreciable.

Rgds,

DM

[makchitale]

This should help:

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a0080093c1b.shtml

http://www.cisco.com/en/US/products/hw/univgate/ps505/products_configuration_example09186a0080094ebe.shtml

Thanks, Mak

[d.majumdar]

Hi Mak,

I am looking for a config wherein the router will dial out to different locations, and these location will hv the dial-in server PC's either configured with an ISDN or Analog Modems.

Hope it clarifies.

Rgds,

DM

[makchitale]

Configuring Dialer profiles will best serve these requirements. You will need to create multiple dialer interfaces per remote dialout location.

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_tech_note09186a0080094e6c.shtml#dialer_profiles_right

Thanks, Mak

[d.majumdar]

Hi Mak,

Do i need to define ip address to each dialer profiles? OR will it get the address from the PEER dial-in server.

Also, can i apply one dialer string to all the dialer profiles?

Rgds,

DM