Hi,
We have created the second IPSEC over L2TP tunnel on one of routers. When we connect first tunnel it worked fine but when we are connecting with this new tunnel it is showing below mentioned error.
*Oct 8 10:04:31: %IP_VFR-7-FEATURE_DISABLE_IN: VFR(in) is manually disabled through CLI; VFR support for features that have internally enabled, will be made available only when VFR is enabled manually on interface Virtual-Access3
However If I see the router then there is no interface virtual access-3
Main-VPN-Router#show ip interface brief
Interface IP-Address OK? Method Status Protocol
ATM0 unassigned YES NVRAM administratively down down
Ethernet0 unassigned YES NVRAM up up
FastEthernet0 unassigned YES unset up up
FastEthernet1 unassigned YES unset down down
FastEthernet2 unassigned YES unset down down
FastEthernet3 unassigned YES unset down down
NVI0 unassigned YES unset up up
Virtual-Access1 unassigned YES unset up up
Virtual-Access2 unassigned YES unset up up
Virtual-Access4 unassigned YES unset down down
Virtual-Template1 192.168.234.254 YES unset up down
Virtual-Template2 192.168.19.1 YES unset up down
Vlan1 unassigned YES unset up up
Vlan10 192.168.19.1 YES NVRAM up up
Vlan20 192.168.234.254 YES NVRAM up up
Can any one please guide me what actually went wrong. I re-verify the configurations, it is fine.
